|
|
|
 |
MONITORING SYSTEMS |
|
| |
 |
SUNMETER
measures irradiation with a silicon cell using our TZOS (True Zero-Ohm Shunt) technology; trough a D.S.P. Signal is filtered and linearized. It is designed to meet five requirements: a high degree of linearity of measurement, compatibility with any data logger, reliability, easy to install, contained price. |
| Input |
|
| Irradiation range: |
0 – 1250W/m2 temperature compensated |
| Temperature Range: |
-30° - + 90° C with external PT100 |
| Out |
|
| Voltage: |
0 - 10V, 0 - 5V (optional 0 – 40mV adapter kit) |
| Current: |
0-20mA, 4-20mA |
| Digital: |
RS485 standard Modbus RTU |
| Out. Precision |
|
| Irradiation: |
+/- 3% [ in assessment course.. ] |
| Temperature: |
+/- 0,5°C |
| Supply : |
9 – 30 Vdc protected against reverse polarity, Short circuit |
| Encapsulation: |
Resin UV resistant |
| Case: |
Stainless steel with screw-clamp to fix it on modules or montage profile |
| Wire: |
10 pin IP67 degree |
| Dimensions: |
7 x 11 x 2,2 cm. |
Every solarimeter is 2 point calibrated with a primary sensor referenced to a first class pyranometer
|
|
SMScan |
It is a visualizing kit useful to read the output of SUNMETER and/or TEMMETER. Supply: a 9Vdc battery.
It is possible to choose a cable of a few dozen meters to connect SMScan to SUNMETER or TENMETER with a RJ connection.
SMScan is expecially functional for commisioning and plant's tests.
A 5 meters cable with two connectors to connect the SMsacn to SUNMETER e TENMETER is optional. |
|
|
|
LITEMETER |
measures solar radiation by means of a monocrystalline silicon cell.
Distinctive feature: no PVC element exposed to the Sun, autopowered, bracket for rapid insertion on the PV installation, possibility to choose the amplified output to guarantee a lower signal noise. |
|
|
| Input |
|
| Power range: |
0 – 1250W/m2 |
| Spectral range: |
0,3 μm – 1,1μm |
| Temperature range: |
-10°/+80° C with external PT100 |
| Output |
|
| Irradiance: |
80mV @1000W/m2 STC |
| Ampl. Irr.: |
4V @ 1000W/m2 STC (5V @ 1250W/m2 STC) |
| Output precision |
| Irradiation: |
+/- 5% |
| Supply: |
Auto-powered |
| Case: |
Stainless steel and aluminium with screwclamp to fix it on modules or montage profile. |
| Wire: |
50cm cable UV resistant |
| Connectors: |
3 pin, IP67 degree |
| Dimensions: |
50x70x18mm in addition to the case
dimensions |
|
|
|
TEMMETER |
it is a PT100 ready to be installed with a fastener that takes it attached, without sticky substances, to the under-surface of the PV module |
|
|
|
|
| To receive techincal assistance write to: support@soluzionesolare.it |
|
|
|
